Demountable Transformer Manufacturer,Supplier and Exporter in India
Product Code : EL-E-10751
Consists of the following items:
With one end shapered to part of a cone for maximum flux density.
Hole drilled through total length along cone axis to take a light beam.
Pole pieces will accept support rods and shading ring of accessory set 2 and may be clamped at any separation on U-core, or in contact as a non laminated I-core.
Laminated U and I cores of low-loss magnetic material, to form a closed core of cross-section 25mm in plane of laminations, 32mm perpendicular to them, I-core length 102mm, U-core external height 102mm, internal height to take bobbin length 77mm.
Cast aluminum alloy stand consisting of a heavy base on four rubber feet with two removable clamping arms.
Integral support for arms, to rear, is below the level of the pole-pieces.
Arms pivot on steel spindle with adjustment of knobs to rear bringing hard rubber pads at a front end of arms to bear on transformer core.
Synthetic hammer finish except of clean metal in channel and 4mm hole to take an earthling plug lead.
Coils for demountable transformer.
Connection to top and of bobbin. Front panel clearly marked with number of turns.
The 300 and 600 turns coils, intended for low voltages, each have connection to pair of 4mm sockets at 19mm spacing.
The 1200-,3600- and 12000- turn coils may be used on a mains supply and are wired to plug half of three pin flex connector.
Each pin wired to front panel and green 4mm sockets.
A separate mains connector, consisting of three pin socket and 1.8m three core flex, is supplied with each mains coil.